SIG SAUER ISSUES A RECALL NOTICE COVERING SOME OF ITS RIFLES

SIG SAUER, Inc. has determined that a limited number of rifles in the SIG716 DMR®, SIG516® Carbon Fiber and SIGM400® Predator models are subject to a Safety Warning and Recall Notice. Some models were built with a two-stage SIG SAUER trigger that may have an improperly heat-treated hammer. Over time, this could result in a trigger malfunction creating a significant safety hazard. SIG SAUER is issuing a mandatory recall to replace the hammer and trigger assembly in these specific rifles. This recall does not affect any military or law enforcement rifles or any SIG MCX®/SIG MPX® products.

SIG SAUER will correct any of the affected firearms at no cost to the customer.

The firearms affected by the recall can be identified by the presence of a SIG mark etched into the hammer. See image below.

SIG SAUER Rifle Safety Warning Two-stage SIG SAUER trigger

To determine if a rifle is subject to the recall, take the following two actions:

  • Enter your firearm’s 9-digit serial number in the box below.
    • The serial number is located on the left side of the lower receiver.
    • NOTE: The serial number will never contain letters “i” or “o”.
  • If your firearm’s serial number is identified to be one of those affected by the recall, stop using the firearm immediately and follow the four corrective steps below.

 

Serial Number Look Up (Click Here)

This entry was posted in Recall Notices and tagged , , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s